Yealink VC400 Administrator's Manual page 65

Parameter DHCP Option
Protocol
Servers
Vendor-Specific
Information
Vendor Class
Identifier
TFTP Server
Name
Bootfile Name
For more information on DHCP options, refer to
http://www.ietf.org/rfc/rfc2131.txt?number=2131
http://www.ietf.org/rfc/rfc2132.txt?number=2132
To make the system gather network settings via DHCP options, you need to contact your
network administrator to configure the DHCP server properly.
DHCP feature parameters on the system are described below:
Parameter
Enables or disables the system to
obtain network settings from the
DHCP server.
Default: Enabled
DHCP
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Configures the host name of the
system.
Default: Blank
Note: When the system broadcasts
DHCP DISCOVER messages, it will
report the configured host name to
Host Name
the DHCP server via DHCP option
12. Host name is optional, so it is not
a mandatory configuration item. For
more information, contact your
network administrator.
If you change this parameter, the
system will reboot to make the
client by IP address.
43 Identifies the vendor-specific information.
60 Identifies the vendor type.
Identifies a TFTP server when the 'name' field in
66 the DHCP header has been used for DHCP
options.
Identifies a bootfile when the 'file' field in the
67
DHCP header has been used for DHCP options.
or
.
Description
Configuring Network
Description
Configuration Method
Remote Control
Web User Interface
Web User Interface
49