Part Names; Led Display - Mitsubishi Electric MELSEC iQ-F FX5 User Manual

2.4

Part Names

This section describes the names of each part of the temperature control module.
2-φ4.5 mounting holes
[3]
[2]
[1]
[9]
[10]
No. Name
[1] Terminal block (Spring clamp terminal
block)
[2] Expansion cable
[3] Direct mounting hole
[4] Operations status display LEDs
[5] Extension connector
[6] Name plate
[7] DIN rail mounting groove
[8] DIN rail mounting hook
[9] Pullout tab
[10] Power connector

LED display

The following table lists the LED display.
LED display
POWER
RUN
ERROR
OUT1 to OUT4
2 SPECIFICATIONS
20
2.4 Part Names
[4]
[5]
Description
Used in temperature sensor and current sensor (CT) inputs, and transistor outputs.
Cable for connecting the module when adding the temperature control module.
Screw holes (2-φ4.5, mounting screw: M4 screw) for direct installation.
Indicates the operating status of the module. (Page 20 LED display)
Connector for connecting the extension cable of an extension module.
The product model name and manufacturer's serial number are shown.
The module can be installed on DIN46277 rail (35 mm wide).
Hook for mounting the module on a DIN rail of DIN46277 (35 mm wide).
They are used when drawing out an extension cable.
Connector for connecting the power cable. (Page 73 Power Supply Wiring)
LED Description
color
Green Indicates the power supply status.
ON: Power ON
OFF: Power OFF or module failure
Green Indicates the operations status.
ON: Normal operation
OFF: Error
Red Indicates the error status.
ON: Minor error or major error
Flashing: Moderate error or major error
OFF: Normal operation
Green Indicates the output status.
ON: OUT1 to OUT4 output on
ON: OUT1 to OUT4 output off
[6]
[7]
[8]