■Setting unit
The value to be set differs depending on the value stored in 'CH1 Decimal point position' (Un\G400). (Page 128 CH1
Decimal point position)
• No decimal point (0): Set a value in increments of 1 ( or digit).
• If there is 1 digit (1) past the decimal point: Set a value (the value multiplied by 10) in increments of 0.1 ().
■Default value
The default value is 0.
CH1 Alert set value 2
Set the temperature to turn ON CH1 alert 2 (Un\G401, b9) according to the selected alert 2 'alert mode' (Un\G533).
For 'CH1 Warning Occurrence Contents' (Un\G401), refer to the following.
Page 128 CH1 Alert definition
For details of the alert function, refer to the following.
Page 54 Alert Function
■Buffer memory address
The following table shows the buffer memory address of this area.
Buffer memory name
CH Alert set value 2
CH Alert set value 2 (If using FX3 allocation mode)
■Alert mode
Set the alert mode of Alert 2 in the following buffer memory area. The alert mode of Alert 2 corresponds to 'CH1 Alert set
value 2' (Un\G435).
• 'CH1 Alert 2 mode setting' (Un\G534)
■Setting range
For the settings range, refer to the following.
Page 137 Setting range
■Setting unit
For the settings unit, refer to the following.
Page 138 Setting unit
■Default value
The default value is 0.
APPX
138
Appendix 4 Buffer Memory Areas
CH1
CH2
435
635
50
90
CH3
CH4
835
1035
130
170