Peeling-Off On Demand Without Present Sensor - CAB SQUIX Configuration Manual

12 I/O Interface
12.3.2

Peeling-off on Demand without Present Sensor

In the peel-off mode with PS800 or PS900 the label removal from the peel position is detected by an optical sensor.
Using the I/O interface the label removal can be confirmed by the external signal LBLREM. That way it is possible to
operate the printer in peel-off mode without present sensor.
Starting Print and Confirming Label Removal with Two Signals
Requirements:
• Operation without present sensor.
• External circuit as shown in Figure 29
Setting Printing > Print on Demand = "On".
•
Setting Interfaces > I/O > Automatic LBLREM = "Off"
•
Operation:
 Send a print job.
 Activate START.
The first label will be printed an transported to the peel position.
 Remove the label.
 Confirm the label removal with signal LBLREM.
 Activate START to start the next cycle.
-
-
-
FEEDON
-
GND_INT
-
-
JOBRDY
READY
-
REPRINT
START
PAUSE
RIBWARN
LBLREM
JOBDEL
RSTERR
P24_INT
P24_EXT
PEELPOS
ERROR
STOP
-
GND_EXT
Operation with external voltage supply
Figure 29 External circuit for peeling-off on demand without present sensor with two signals
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20 P24
21
22
23
24
GND
25
Pin
- 1
- 2
- 3
FEEDON 4
- 5
GND_INT
6
- 7
- 8
9
JOBRDY
READY 10
- 11
12
REPRINT
START 13
PAUSE 14
15
RIBWARN
LBLREM 16
JOBDEL 17
18
RSTERR
P24_INT 19
P24_EXT 20
PEELPOS 21
ERROR 22
STOP 23
- 24
GND_EXT
25
Operation using the internal voltage
49