Adjusting Label Sensor - CAB A2+ User Configuration Manual

6 Service Functions
6.3

Adjusting Label Sensor

Access only when service key is inserted!
With the Adj. gap sensor function label sensor can be adjusted in the see-through mode. This is necessary if
sensor elements or CPU PCB has been changed.
!
Attention!
Close the print module and the cover after each loading or removal of material. This is required for a
successful adjustment.
MACH4
1. Insert service key into a USB master interface.
Press the menu button.
2.
3. Select Service > Adj. gap sensor menu.
Press the  button.
4.
The display shows Remove labels .
5. Remove labels and transfer ribbon from the printer.
Press the  button.
6.
In the display the Insert liner message appears.
7. Load liner (without labels). Ensure that no labels are found on the liner near the sensor. Otherwise, the result will
be faulty adjustment and device malfunction.
Press the  button.
8.
The message Ribbon, no liner is shown.
9. Remove liner, load transfer ribbon.
Press the  button.
10.
In the display the Insert liner message appears again.
11. Leave transfer ribbon in the printer, load liner additionally .
Press the  button.
12.
OK appears in the display after a successful adjustment.
Confirm completion of the adjustment with the  button.
13.
A+ Series
1. Insert service key into a USB master interface.
Press the menu button.
2.
3. Select Service > Adj. gap sensor menu.
Press the  button.
4.
The display shows Remove labels .
5. Remove labels from the printer.
Press the  button.
6.
In the display the Insert liner message appears.
7. Load liner (without labels). Ensure that no labels are found on the liner near the sensor. Otherwise, the result will
be faulty adjustment and device malfunction.
Press the  button.
8.
OK appears in the display after a successful adjustment.
Confirm completion of the adjustment with the  button.
9.
Error during adjustment:
If an error occurs while adjusting the label sensor, Error appears in the display. If an error occurs again when
repeating the adjustment, one of the following assemblies may be defective:
• Label sensor elements
• Connection cables of the label sensor
• CPU PCB
41