Installing The Present Sensor - CAB MACH2 Operator's Manual

8 Accessories
42
8.2

Installing the Present Sensor

i
Note!
A label liner thickness of 0.006 mm ± 10% and a weight of 65 g/m2 ± 6% are recommended.
The Present Sensor will take labels up to a max. width of 118 mm.
When using the Present Sensor, set the stop position (printer command ^E) to 13.
The Overview of the Label Dispenser
5
Fig. 25 Overview of the Label Dispenser
Preparation Steps
i
Note!
Please see the Section  8.1 on page 40 Preparation Steps to complete the preparation steps before
installing the Present Sensor
Installing the Present Sensor
Fig. 26 Installing the Present Sensor
1. Pass the connection cable (3) through the slot of the printer.
2. Place Present Sensor to align both holes of screw at the printer.
3. Open the cover (4).
4. Tighten the screws (5).
1 2 5
4
3
3
1 Paper sensor
2 Paper feed roller
3 Connection cable of Present Sensor
4 Cover
5 Screws (Set of 2)
5 5
4
42