Labelling - CAB SQUIX Configuration Manual

6 Configuration
6.1.7

Labelling

If applicator is not installed, access only with service key inserted.

 Start menu.
 Select Setup > Labelling.
Parameter
Transfer mode
Cycle sequence
Waiting position
Blow time
Roll-on time
Support delay on
Support delay off
Start delay
Vacuum delay
Vacuum control
Peel-off position
Parameters of the Setup > Labelling menu
Table 11
Meaning
Setting the operation mode Stamp on, Roll on, Blow on
Setting the application mode Print-Apply / Apply-Print
Print-Apply:
An external start signal releases the print of a label and following the
application of the label. After a cycle is complete, the pad without label
waits in the start position.
Apply-Print:
An extra signal starts the print of the first label and the transfer of the
label to the pad. The external start signal releases the application of the
label and following the print and transfer of the next label.
After a cycle is complete, the pad with a label is in the waiting position.
up: Pad waits in the start position for the start signal
down: Pad waits in the labelling position for the start signal
Only at Transfer mode = Blow on and Cycle sequence = Apply-Print
Switch-on time (max. 2,5 s) of the blowing air for the label transfer
Only at Transfer mode = Blow on
Dwell time (max. 5 s) of the pad in the labelling position
Only at Transfer mode = Roll on
Setting the switch-on delay (max. 2,5 s) for the supporting air between
print start and switching on the supporting air. The delay prevents
swirling at the front of the label and, consequently, avoids faults when
the label is being picked up from the printer.
Setting the switch-off delay (max. 2,5 s) for the supporting air between
the end of label forwarding and switching on the supporting air. The
delay can be useful to separate the rear edge of the label from the
carrier to avoid errors and to improve the accuracy of label positioning
Delay (max. 2,5 s) between start signal and the start of an labelling
cycle.
Allows e.g. the use of product sensors at conveyors.
On - The vacuum will be switched on after the label feed is completed.
Off - The vacuum will be switched on when the label feed starts.
Setting the label transfer check from printer to pad and from pad to
product by the vacuum sensor
Shift the position of the dispensed label relative to the dispensing edge.
The setting can also be adjusted by the software.
The settings of configuration and software are added together.
17
Default
Stamp on
Print-Apply
up
1000 ms
1000 ms
0 ms
0 ms
0 ms
Off
On
0.0 mm