Circuit Diagram Of Inputs And Outputs - CAB SQUIX Configuration Manual

12 I/O Interface
Pin Signal Name
21 PEELPOS
Bit 3
22 ERROR
23 STOP
24 - -
25 GND_EXT
Table 29 Pin assignment of the I/O interface
12.2

Circuit Diagram of Inputs and Outputs

Digital Inputs
• conform to IEC/EN 61131-2 (Type 3)
• Operating voltage: 24 V DC (9,6..35 V)
• Switching logic: PNP switching
• Low level „0": < 7 V DC
• High level „1": > 11 V DC
• Input current per channel: 1,5..2,5 mA (at 24 V DC)
• Reverse polarity protection: yes
• ESD protection: conform to IEC/EN 6100-4-4
Pin 20 P24_EXT
Pin 1
Pin 12 REPRINT
Pin 13 START
Pin 14 PAUSE
Pin 16 LBLREM
Pin 17 JOBDEL
Pin 18 RSTERR
Pin 23 STOP
Pin 25 GND_EXT
Figure 26 Connecting inputs
Description
Label in peel-off position
For peel-off mode only.
A label is in peel-off position.
User Bit 3 is set
General error message
The operation will be stopped and the error type will be
displayed.
Stop signal to interrupt the operation
Do not use
Ground of the external 24 V
-
Activation / Active State
+24 V on Pin 21
0 V on Pin 22
Switch on +24 V between
Pin 23 and Pin 25
Digital Outputs
• conform to IEC/EN 61131-2
• Operating voltage: 24 V DC (11..35 V)
• Switching logic: PNP switching
• Output current per channel: 625 mA
(overload protection)
• Short-circuit protection: yes
• Reverse polarity protection: yes
• ESD protection: conform to IEC/EN 6100-4-4
Pin 20 P24_EXT
Pin 3 -
Pin 4 FEEDON
Pin 5 -
Pin 9 JOBRDY
Pin 10 READY
Pin 15 RIBWARN
Pin 21 PEELPOS
Pin 22 ERROR
Pin 25 GND_EXT
Figure 27 Connecting outputs
47