Tearing-Off; Cutting; Peeling-Off - CAB SQUIX Configuration Manual

6 Configuration
16
6.1.4

Tearing-off

 Start menu.
 Select Setup > Tearing-off.
Parameter
Tear-off mode
Tear-off position
Table 8
6.1.5

Cutting

If cutter is not installed, access only with service key inserted.

 Start menu.
 Select Setup > Cutting.
Parameter
Cut position
Perforation level
Table 9
6.1.6

Peeling-off

If peel-off module is not installed, access only with service key inserted.

 Start menu.
 Select Setup > Peeling-off.
Parameter
Peel-off position
Backfeed delay
Backfeed position
Table 10
Meaning
Positioning the label medium for tearing off at the tear-off plate.
On: Additional advancement of the label medium which positions the
label gap after the last printed label at the dispense plate.
Off: Label advance stops once the last label has fully passed the print
line.
Shifting of the tear-off position in the direction of paper flow. With
positive values, the label strip is transported farther out of the printer.
Parameters of the Setup > Tearing-off menu
Meaning
Offset of the cut position relative to the rear label edge.
The setting can also be adjusted by the software.
The settings of configuration and software are added together.
with perforation cutter only
Setting of the perforation depth.
The setting can also be adjusted by the software.
The settings of configuration and software are added together.
Parameters of the Setup > Cutting menu
Meaning
Shift the position of the dispensed label relative to the dispensing edge.
The setting can also be adjusted by the software.
The settings of configuration and software are added together.
Delay time between removing the label from the peel position and the
backfeed of the label.
Offset of the backfeed movement
Parameters of the Setup > Peeling-off menu
16
Default
Ein
0.0 mm
Default
0.0 mm
0
Default
0.0 mm
250 ms
1.0 mm