I/O Interface; Pin Assignment - CAB SQUIX Configuration Manual

I/O Interface

12
46
For use in a network the printer is equipped with an I/O interface.
12.1

Pin Assignment

The interface has a 25 pin SUB-D connector.
Pin 1
Pin 13
Figure 25
i
Note!
The function of the outputs on the pins 4, 9 10 and 21 can be re-defined temporarily by direct programming
e.g. to control external devices with the user bits 0 to 3  Programming Manual.
Pin Signal Name
1 - -
2 - -
3 - -
4 FEEDON
Bit 0
5 - -
6 GND_INT
7 - -
8 - -
9 JOBRDY
Bit 1
10 READY
Bit 2
11 - -
12 REPRINT
13 START
14 PAUSE
15 RIBWARN
16 LBLREM
17 JOBDEL
18 RSTERR
19 P24_INT
20 P24_EXT
Pin 14
Pin 25
I/O interface
Description
Do not use
Do not use
Do not use
Media transport ON
Labels are fed by the printer
User Bit 0 is set
Do not use
Ground (0 V)
for sensors or trigger switches
Do not use
Do not use
Print job ready
Print jobs are stored in the print module.
User Bit 1 is set
Printer is ready
User Bit 2 is set
Do not use
The last printed label will be repeated.
Print start signal
only for Print on demand = On
Pause ON/OFF
Warning end of ribbon
The ribbon supply roll diameter has undershot a predefined
level
Label removed
For peel-off mode only.
Confirmation of the superior control that the label has been
taken from the peel-off position.
Required for the validity of a new start signal.
Cancel print job
The current print job is canceled and deleted from the print
buffer.
Reset
Error state of the printer will be reset.
Internal operating voltage +24 V, Si T 100mA
for external consumers e.g. sensors, trigger switches
External operating voltage +24 V
Activation / Active State
+24 V on Pin 4
+24 V on Pin 9
+24 V on Pin 10
+24 V between Pin 12 and Pin 25
+24 V between Pin 13 and Pin 25
Pause ON when +24 V between
Pin 14 and Pin 25
0 V on Pin 15
Switch on +24 V between
Pin 16 and Pin 25
Switch on +24 V between
Pin 17 and Pin 25
Switch on +24 V between
Pin 18 and Pin 25
46