Maintenance; Cleaning By The Operator; Cleaning The Label Sensor - CAB Hermes C Series Service Manual

3

Maintenance

3.1

Cleaning by the Operator

The following cleaning work is described in the "Operator's Manual":
• Cleaning the device
• Cleaning the printheads
• Cleaning the print rollers
3.2

Cleaning the Label Sensor

Figure 1 Cleaning the label sensor
Danger!
Risk of death via electric shock!
 Before opening the rear cover, disconnect the device from the mains supply and wait at least one
minute until the power supply unit has discharged.
1. Unplug the printer from the electrical outlet and remove the rear cover.
2. Remove the material from the printer.
3. Unplug the connector (2) of the cable (1) from the connector of the label sensor (3).
4. Loosen the screw (7) and pull the label sensor (3) with spindle (5) and the cover (6) out of the profile (4).
5. Clean the label sensor (3) with a brush or a cotton swab soaked in pure alcohol.
6. Move the label sensor (3) with spindle (5) and cover (6) into the profile (4) in the former position.
7. Fix the assembly with the screw (7).
8. Plug in the connector (2) of the cable (1) at the label sensor (3).
9. Mount the cover and restore all connections.
10. Adjust the label sensor  Operator's manual.
1 2 3
4 3 5
7
6 7