Table of Contents
Advertisement
8
Diagnostic Functions
8.2
Label Profile
The Label profile function carries out a longer label advance. It saves the values measured by the label sensor here and
then prints them out in a diagram.
The printout is used to check label detection in conjunction with the optical properties of the label medium.
The printout occurs using the heat level and print speed specified in the Setup > Printing menu.
i
Notice!
The printout occurs without taking the label gaps into consideration. This is why endless media are most
suitable for this purpose.
Select the label sensor to be tested in the Setup > Labels menu page 15.
Load the label medium to be tested into the printer.
Start menu.
Select Diagnostics > Label profile.
The printer performs a longer label advance. The label sensor measures the transparency/reflection capacity of
the label material here. The message Insert appears in the display once the advance is complete.
Insert printable medium (labels, endless paper) which extends across the entire printing width.
If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum width.
Start the diagram printout with Continue.
The printout can be canceled with
Thu Aug 11 12:38:19 2016
1
cab SQUIX 4/300MP
Firmware V5.00 (Jul 28, 2013) - #164162031171
2
3
Peripheral device : None
4
50 mm/s - Gap Sensor - brightness 5 %
5
71.09mm - σ² 0.002mm²
Label profile
Figure 18
No.
Information
1
Date and time of the printout
Device type
Version and creation date of the firmware
Serial number of the PCB CPU
Firmware version and serial number of the label sensor
Coordinate in the direction of paper flow at which the label start was detected
2
3
Type of peripheral device connected
Print speed, method of label detection (Gap sensor / Bottom-reflect sensor)
4
Brightness of the sensor LED during the measurement
5
Average value and variation of label distances
Information in Label profile
Table 26
.
Label profile
35
Hide quick links:
Advertisement
Table of Contents
