Errors - CAB SQUIX Configuration Manual

6 Configuration
20
I/O
Parameter
START mode
REPRINT mode
Automatic LBLREM
Table 16
6.1.9

Errors

 Start menu.
 Select Setup > Errors.
Parameter
Error-Reprint
Syntax error
Barcode error
Network error
Table 17
Meaning
Configuration of the I/O signal START
Edge: A label will be printed by switching on 24V between START and
GND_EXT.
Level: In Rewind mode labels are printed as long as 24V are switched on
between START and GND_EXT.
In Peel-off mode a label will be printed after receiving the signal
LBLREM as long as 24V are switched on between START and
GND_EXT.
Configuration of the I/O signal REPRINT
Edge: A label will be repeated by switching on 24V between REPRINT and
GND_EXT.
Level: A label will be repeated as long as 24V are switched on between
REPRINT and GND_EXT.
START/REPRINT select: A label will be repeated when 24V are switched on
between REPEAT and GND_EXT and the START signal will be activated
additionally.
Simulation of the I/O signal LBLREM
For peel-off mode without present sensor
On: With the signal START the removing of the previous label also will be
confirmed.
Off: To confirm the label removing the signal LBLREM must be activated.
Parameters of the Setup > Interfaces > I/O menu
Meaning
On: With a correctable error and corresponding troubleshooting, the label
being printed when the error occurs is repeated.
Off: Print job is continued with the next label.
Printer switches to error mode after receipt of an incorrect command.
On: With faulty barcode contents or size specifications, printing is
interrupted.
Off: Printing is not interrupted if an error occurs. If barcode contents
are faulty, the printer attempts to replace the incorrect data with valid
characters (e.g. zeros). If barcode size specifications are faulty, a gray
area is printed instead of the barcode.
Printer switches to error mode when problems with the network
connection occur.
Parameters of the Setup > Errors menu
20
Default
Edge
Edge
Off
Default
On
On
On
Off