Labels; Ribbon - CAB SQUIX Configuration Manual

6 Configuration
Parameter
Print on demand
Reprint
Parameters of the Setup > Printing menu
Table 5
6.1.2

Labels

 Start menu.
 Select Setup > Labels.
Parameter
Label sensor
Extrapolate labels
Parameters of the Setup > Labels menu
Table 6
6.1.3

Ribbon

 Start menu.
 Select Setup > Ribbon.
Parameter
Transfer print
Warn level ribbon
Pause on warning
Parameters of the Setup > Ribbon menu
Table 7
Meaning
Peel-off mode : Behavior after removing a label from the peel position
On: The next label will be printed and peeled-off after touching
Off: The next label will be printed and peeled-off immediately
Cut mode : Behavior between the cuts
On: After cutting the next label will be printed and cut after touching
Off: All labels will be printed and cut nonstop
Printing of another label with the information of the previous print job by
touching .
This function can be executed until the print buffer is cleared with
.
Re-render: Adaption of counter values, variable data can be newly put in.
Duplicate: New label is identical with the last label of the print job.
Off: No reprint
Meaning
Method for detecting the starting end of the label.
Gap Sensor: Detection using changes in the transparency between the
label and label gap.
Bottom-Reflect: Detection using reflex marks on the bottom of the medium.
Continuous media: Checking the existence of media only.
The positions of the labels which are between the label sensor and the
printhead are calculated from the first label recognized by the sensor
and the programmed label distance. That way those labels can be
printed although the printhead previously was open.
Meaning
On: Sensor for monitoring the transfer ribbon is activated.
Off: Sensor for monitoring the transfer ribbon is not activated.
The setting can be overwritten for each print job via software. The basic
setting is not changed by this.
Threshold diameter (32–74 mm) of the ribbon supply roll, if the value is
undershot the "ribbon low" message will be activated
The print job will be interrupted when the "ribbon low" message appears
15
Default
Aus
Re-render
Default
Gap sensor
Off
Default
On
Off
Off