Loading Media In Trays 1, 2, And 3; Information About Loading Media In Trays 1, 2, And 3 - Xerox Versant 180 Press User Manual

Paper Type Feed Direction
8.5 x 14 / B4 un- SEF
coated and coated
11 x17 / A3 un- SEF
coated and coated
12 x 18 / SRA3 SEF
coated and un-
coated
13 x 19.2 coated and SEF
uncoated

Loading Media in Trays 1, 2, and 3

Information About Loading Media in Trays 1, 2, and 3

Trays 1, 2, and 3 are identical. Each tray has a capacity of 550 sheets of 20 lb./75 gsm
paper. Stock can be Long Edge Feed (LEF) or Short Edge Feed (SEF), landscape or portrait.
Note
Each feeder tray has a stock loading label. When loading media into the tray, refer to
the labels on the inside panel of the feeder tray for the correct orientation of that stock
type.
Loading Paper in Trays 1, 2, and 3
Note
A paper jam may occur if a tray is opened while it is being used to feed stock.
1. Select the appropriate paper stock for your print or copy job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
5. Load and align the edge of the paper against the left edge of the tray.
Paper can be loaded either in the LEF/portrait or SEF/landscape direction.
6. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
® ®
Xerox Versant 180 Press
User Guide
Paper Weight Simplex/Duplex
52 to 300 gsm Simplex / Duplex
52 to 300 gsm Simplex / Duplex
52 to 300 gsm Simplex / Duplex
52 to 300 gsm Simplex / Duplex
Paper and Media
Prints Per Minute
50 ppm / 25 ppm
44 ppm / 22 ppm
41 ppm / 21 ppm
40 ppm / 20 ppm
4-5