Cleaning The Fuser Assembly; Replacing Consumable Supplies - Xerox Versant 180 Press User Manual

Cleaning the Fuser Assembly

If you see dry ink/toner debris on the back side of the print output, select and run the
Clean Fuser Assembly routine from the press UI to clean the fuser component and
address this image quality issue caused by contaminants in the fuser.
Note
If you still notice contaminants on the back of the prints after running this procedure,
contact Service. Dry ink/toner debris may be coming from the Transfer roll area instead
of the fuser.
1. Press the Machine Status button on the UI.
2. Select the Tools tab.
3. Select Setup & Calibration > Clean Fuser Assembly.
4. From the screen that displays, specify the paper tray to use and the number of blank
sheets to print for the "Clean with Paper" method of removing the unfused dry
ink/toner.
5. From Paper Supply, select the paper tray to use.
Note
Any type of paper and size can be used. However, the smooth surface of coated paper
does offer more contact area to the pressure roll.
6. From Number of Sheets, select the number of blank sheets to print (1 to 5).
Note
For best results, run a minimum of 5 sheets.
7. Select Save.
8. Press the Start button.
The system begins the cleaning process and displays a "successfully completed"
message when finished.
9. Select OK.
Note
The process with 5 sheets of paper will take approximately one minute.

Replacing Consumable Supplies

The following items are the Customer Replaceable Units (CRU) for the press. It is
recommended that you have a supply of these items available to eliminate down time
when they need to be replaced.
• Dry Ink/Toner cartridges (C, M, Y, K)
• Drum cartridges (C, M, Y, K)
• An empty Waste Dry Ink/Toner bottle
• Suction Filter
Refer to www.xerox.com
® ®
Xerox Versant 180 Press
User Guide
for the latest consumable part numbers.
Maintenance
5-5