Xerox Versant 180 Press User Manual page 120

Maintenance
After you replace the filter, you will need to contact the system administrator who will
log into administrator mode and reset the counter to zero (0) for this CRU.
Caution
Make sure the press is powered off before performing this procedure.
1. At the back of the press, locate the Suction filter cover on the lower panel.
2. Use the Torx driver to remove the screw on the right side of the cover by turning the
screw counterclockwise.
3. Pull out and remove the Suction Filter Cover.
4. Grasp the handle of the filter box and pull straight out.
5. Remove the Suction filter out of the box.
6. Place the new Suction filter into the box and push the tray back in until it stops and
is flush with the press.
7. Place the cover back onto the filter box area. Make sure to first insert the left two
tabs of the cover into the left side of the box area. Then push the entire cover flush
to the press.
8. Insert the Torx driver with the screw attached into the cover and turn clockwise to
tighten.
9. Either log in as the Administrator or ask the Administrator to perform the following
steps to reset the counter to zero (0).
a) At the UI, press the Machine Status button.
b) From the screen that displays, select the Tools tab.
c) Select System Settings > Common Service Settings > Maintenance.
d) Use the up/down arrow buttons to access the next Maintenance screens.
Note
After selecting the icon in following step, there is a 4 second delay before the
Technical Key Operator feature displays.
e) Select the Technical Key Operator icon. The Technical Key Operator feature
displays.
5-12
® ®
Xerox Versant 180 Press
User Guide