Oracle X6 series Administration Manual page 75

a. Log in to the Oracle ILOM web interface.
For instructions, see
In the navigation pane, click ILOM Administration > Connectivity, and then
b.
click the DNS tab.
To enable Oracle ILOM to automatically retrieve DNS information from a
c.
DHCP server on the network, select the Enabled check box.
If you did not enable Auto DNS via DHCP, enter one or more DNS server IP
d.
addresses and search paths.
Enter the DNS Timeout as an integer between 1 and 10.
e.
f. Enter the DNS Retries as an integer between 0 and 4.
g. Click Save.
2. To configure DNS server information from the Oracle ILOM command-line
interface (CLI), perform the following steps:
a. Log in to the Oracle ILOM CLI.
For instructions, see
b. To enable Oracle ILOM to automatically retrieve DNS information from a
DHCP server on the network, use the
set /SP/clients/dns auto_dns=enabled
c. If is disabled, set one more nameservers and searchpaths:
auto_dns
set /SP/clients/dns nameserver=ip_address_1,ipaddress_2,ipaddress_3 searchpath=
domain_1.com,domain_2.edu,and so on
You can specify up to three IP addresses and up to six searchpaths.
d. Set the DNS timeout and retries:
set /SP/clients/dns timeout=timeoutInSeconds retries=retries
Where timeout is an integer between 1 and 10, and retries is an integer between 0 and 4.
Configure DNS Server Information on the Service Processor (Oracle ILOM)
"Accessing Oracle ILOM" on page
"Accessing Oracle ILOM" on page
set
21.
21.
command:
Configure the Service Processor 75