Table of Contents
Advertisement
Set SP Host Power Policy at Boot
d.
In the Actions drop-down list, select Enable.
To set a power-on policy in the Oracle ILOM command-line interface (CLI),
2.
perform the following steps:
a.
Log in to the Oracle ILOM CLI.
For instructions, see
Use one of the following commands:
b.
■
■
The power-on policies are mutually exclusive, that is, only one can be enabled at a time.
For more information about each policy, see the Related Information section following this
procedure.
Related Information
Power-On and Cooling-Down Policies Configurable from the Server SP, Oracle ILOM
■
Administrator's Guide for Configuration and Maintenance, Firmware Release 3.2.x
44
Oracle X6 Series Servers Administration Guide • April 2016
"Accessing Oracle ILOM" on page
set /SP/policy HOST_AUTO_POWER_ON=enabled
set /SP/policy HOST_LAST_POWER_STATE=enabled
21.
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the X6 series and is the answer not in the manual?
Questions and answers