Table of Contents
Advertisement
Modify iSCSI Virtual Drive Properties in UEFI Boot Mode (BIOS)
The Port Configuration screen appears.
7.
In the Port Configuration screen, perform the following steps:
a.
Set the iSCSI Mode property to Enabled.
Set the Internet Protocol property to IPv4.
b.
c.
Set the Connection Retry Count property to 1.
d.
Set the Enable DHCP property to Enabled or Disabled to specify an
addressing method for the iSCSI initiator.
e.
If you set the Enable DHCP property to Disabled, specify the Initiator IP
Address, Initiator Subnet Mask, and Gateway.
Note -
60
Oracle X6 Series Servers Administration Guide • April 2016
Use the same subnet.
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the X6 series and is the answer not in the manual?
Questions and answers