Oracle X6 series Administration Manual page 51

reset. For subsequent power resets, the server automatically reverts to booting from the boot
order list.
Before you begin, ensure that you have Reset and Host Control (r) role privileges in Oracle
ILOM.
1. To set a boot device for the next power reset in the Oracle ILOM web interface,
perform the following steps:
a. Log in to the Oracle ILOM web interface.
For instructions, see
b. In the navigation pane, click Host Management > Host Console.
c. In the Next Boot Device drop-down list, select a boot device.
d. Click Save.
Your selection is only valid the next time the server is powered on. To permanently modify
the boot order, see
If you select BIOS from the list, next time you boot you do not have to press F2 to
Note -
access the BIOS Setup Utility.
2. To set a boot device for the next power reset in the Oracle ILOM command-line
interface (CLI), perform the following steps:
a. Log in to the Oracle ILOM CLI.
For instructions, see
b. Use the
set /HOST boot_device
set /HOST boot_device=bootDevice
Where bootDevice is one of the following: default, pxe, disk, diagnostic, cdrom, bios, or
floppy
Related Information
Setting Next Boot Device on x86 Host Server, Oracle ILOM Administrator's Guide for
■
Configuration and Maintenance, Firmware Release 3.2.x
"Accessing Oracle ILOM" on page
"Modify the Boot Order (BIOS)" on page
"Accessing Oracle ILOM" on page
command:
Set Temporary Next Boot Device (Oracle ILOM)
21.
49.
21.
Viewing and Modifying Boot Properties 51