Oracle X6 series Administration Manual page 108

Restore a Saved Oracle ILOM Firmware Configuration (Oracle ILOM)
Note -
sessions resume after the Restore operation is complete.
2. To restore a saved Oracle ILOM configuration in the Oracle ILOM command-line
interface (CLI), perform the following steps:
a. Log in to the Oracle ILOM CLI.
For instructions, see
b.
Use the set command:
set /SP/Config passphrase=passphrase include_faultdata=[true|false]
load_uri=transfer_method://username:password@host/filepath
Where:
■
■
■
■
■
■
Note -
password.
Related Information
Restore the Oracle ILOM Backup XML File, Oracle ILOM Administrator's Guide for
■
Configuration and Maintenance, Firmware Release 3.2.x at
goto/ilom/docs
108 Oracle X6 Series Servers Administration Guide • April 2016
While the Restore operation is taking place, Oracle ILOM sessions are suspended. The
"Accessing Oracle ILOM" on page
passphrase is the passphrase you specified when you exported the XML file. If you
did not specify a passphrase, do not set the passphrase property.
include_faultdata=true includes fault data in the restore, if fault data was included
in the backup. This selection requires a passphrase and is available with Oracle ILOM
3.2.6 or newer.
The fault data backup and restore is reserved for Oracle service personnel when
Note -
they replace the SP.
transfer_method is one of the following protocols: tftp, ftp, sftp, scp, http, or
https.
username and password are your credentials on the remote system where the backup
file is saved.
host is the IP address or hostname of the system where the backup file is saved.
filepath is the relative path to the backup file.
If you transfer the backup file using TFTP, you do not need to provide a username or
21.
http://www.oracle.com/