Configuring Storage Resources; Configuring Raid On The Server - Oracle X6 series Administration Manual

Configuring Storage Resources

This section describes how to configure RAID and iSCSI virtual drives.
RAID arrays can improve performance and increase tolerance for disk failures.
■
If you prefer to run a supported operating system that resides on an external server, you
■
must configure iSCSI virtual drive parameters in the BIOS Setup Utility.
See the following sections:
Task
Configure RAID on the server.
Configure iSCSI virtual drive parameters.

Configuring RAID on the Server

Redundant array of independent disks (RAID) implementations provide increased performance
and data integrity across the available disk space in the server. By mirroring data across drives,
most RAID levels can tolerate disk failures. Additionally, RAID configurations enable you to
designate one or more hot spares. A hot spare is an unused drive on which the data on a failed
drive can be automatically duplicated.
RAID configuration can be done before installing the operating system, and after the operating
system is installed.
Before you install the operating system, you can use the BIOS utilities to configure
■
RAID. This is a necessary step that must be completed before installing the operating
system. For details, refer to your hardware installation guide.
Caution -
After the operating system is installed, you can use the following tools to configure
■
and modify RAID configurations. However this erases all the data on the affected drives,
These procedures erase all data on the disk, including the operating system.
Link
"Configuring RAID on the Server" on page 55
"Modifying iSCSI Virtual Drive
Properties" on page 57
Configuring Storage Resources 55