Oracle X6 Series Servers Administration Guide • April - Oracle X6 series Administration Manual

Modify Oracle ILOM SP Network Settings (Oracle ILOM)
This procedure provides web and command-line interface (CLI) instructions for viewing and
modifying the network settings that are assinged to the SP. For further details about this task,
see the instructions below.
Note -
connection or a dual-stack (IPv4 and IPv6) network connection. Newer enhanced releases
of Oracle ILOM support the ability to configure a static IPv6 gateway address and any of
the following: IPv4 network connection only, IPv6 network connection only, or a dual-stack
network connection (where IPv4 and IPv6 are both enabled). Refer to your product notes to
determine which Oracle ILOM release supports these enhancements.
Log in to Oracle ILOM as an Administrator.
1.
For instructions on how launch Oracle ILOM from the CLI or web interface, see:
Oracle ILOM" on page 21
To modify the SP network settings, perform one of the following:
2.
From the web interface, perform these steps:
■
a.
b.
c.
Note -
To log back in to Oracle ILOM, use the newly assigned service processor IP address.
From the CLI interface, perform these steps:
■
a.
b.
66 Oracle X6 Series Servers Administration Guide • April 2016
Earlier releases of Oracle ILOM support the ability to configure an IPv4 network
Click ILOM Administration > Connectivity > Network.
Modify the settings on the Network Settings page as required.
For further details about how to configure the properties on the Network Settings
page, click the More Details link.
Click Save to save your network property changes in Oracle ILOM.
All user sessions on the SP are terminated when you save IP network property changes.
To view the assigned IPv4 and IPv6 network settings on the SP, type:
For IPv4, type:
show /SP/network
For IPv6, type:
show /SP/network/ipv6
To view the descriptions for each IPv4 and IPv6 network property, type:
For IPv4, type:
help /SP/network
For IPv6, type:
help /SP/network/ipv6
"Accessing