Oracle X6 series Administration Manual page 61

f. Set the Get Target Info Via DHCP property to Enabled or Disabled to specify
an addressing method for the iSCSI target.
If you set the Get Target Info Via DHCP property to Disabled, specify the
g.
Target IP Address, Target Port, and Boot LUN.
When iSCSI is enabled on a network port, PXE is disabled for that port.
Note -
h. Specify the Target Name in iSCSI Qualified Name (iqn) format, for example
iqn.1988-12.com.oracle:X6-2-target
Set the Authentication Type property to CHAP or None.
i.
CHAP refers to Challenge-Handshake Authentication Protocol.
j. Select Save Changes.
8. Press the F10 function key to save your changes and exit the BIOS Setup Utility.
The server reboots.
The newly-configured iSCSI drive does not appear in the BIOS boot list until after you
Note -
install an operating system.
Related Information
"Select UEFI Boot Mode or Legacy BIOS Boot Mode (BIOS)" on page 47
■
Modify iSCSI Virtual Drive Properties in UEFI Boot Mode (BIOS)
.
Configuring Storage Resources 61