Black & Decker MTSA2 Original Instructions Manual page 6

ENGLISH
@
Warning! Contact with or inhalation
of dusts arising from sanding applica-
tions may endanger the health of the
operator and possible bystanders.
Wear a dust mask specifically
designed for protection against dust
and fumes and ensure that persons
within or entering the work area are
also protected.
Thoroughly remove all dust after sanding.
u
Take special care when sanding paint which
u
is possibly lead based or when sanding some
woods and metal which may produce toxic
dust:
Do not let children or pregnant women enter
t
the work area.
Do not eat, drink or smoke in the work area.
t
Dispose of dust particles and any other
t
debris safely.
The intended use is described in this instruc-
u
tion manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.
6
(Original instructions)
Features (fig. A)
Tool shown is MT143. Other tools are available for
use with this tool head.
This tool includes some or all of the following
features.
10. Sander head
11. Sanding base
Assembly
Warning! Before assembly, remove the battery
from the tool.
Fitting and removing sanding sheets
(fig. A)
The sanding head uses pre-cut sanding sheets.
Lock the tool by setting the forward/reverse
u
slider (2) to the centre position.
Before fitting a new sheet, remove the two
u
additional diamond tips (12).
To fit a sanding sheet, line it up with the sand-
u
ing base (11) as shown.
Press the sheet firmly and evenly onto the
u
sanding base, making sure that the holes in the
sheet coincide with the holes in the base.
To remove the sheet, pull it off the sanding
u
pad.
Warning! Never use the sanding head without a
sanding sheet or accessory in place.