Download Print this page

Hints For Optimum Use - Black & Decker MTSA2 Original Instructions Manual

Hide thumbs

Advertisement

Table of Contents
Replacing the diamond sanding tip (fig. B)
Sanding sheets are supplied with two replacement
diamond tips. The diamond tip can be reversed
when worn. When both sides are worn, replace the
diamond tip.
Lock the tool by setting the forward/reverse
u
slider (2) to the centre position.
To reverse the tip, remove it, turn it 180° and
u
press it back onto the base.
To replace the tip, pull the old tip off the base
u
and press a new one onto the base.
Warning! When removing the tip from the pad, be
careful not to pull the pad off the sanding base.
Fitting and removing the dust extraction
adaptor (fig. C)
Line up the dust extraction adaptor (13) with
u
the sanding head (10) as shown.
Press the adaptor firmly and evenly in to the
u
sanding base.
Connect a vacuum cleaner to the dust extrac-
u
tion adaptor.
To remove, pull the dust extraction adaptor (13)
u
out of the sanding head (10).
(Original instructions)
Use
Warning! Let the tool work at its own pace. Do not
overload.
Sanding
Note: Ensure the forward reverse slider (2) is not
in the locked position.
To switch the tool on, press the variable speed
u
switch (1). The tool speed depends on how far
you press the switch.
To switch the tool off, release the variable
u
speed switch.

Hints for optimum use

Sanding
Do not exert too much pressure on the tool.
u
Regularly check the condition of the sanding
u
sheet. Replace when necessary.
When sanding new layers of paint before ap-
u
plying another layer, use extra fine grit.
On very uneven surfaces, or when removing
u
layers of paint, start with a coarse grit. On
other surfaces, start with a medium grit. In
both cases, gradually change to a fine grit for a
smooth finish.
Consult your retailer for more information on
u
available accessories for sanding, polishing,
stripping and scrubbing.
ENGLISH
7

Advertisement

Table of Contents
loading