Check The Air Supply Lubricator Drip Rate - Air Models; Check The Air Filter/Regulator Canister - Air Models - Genie AWP Super Series Service Manual

Service Manual
Checklist A Procedures
A-18 C hec k the Air Supply Lubricator Dri p R ate - Air Models
A-18
Check the Air Supply Lubricator
Drip Rate - Air Models
Genie specifications require that this procedure be
performed every 8 hours or daily, whichever comes
first.
Maintaining the proper oil drip rate into the air
supply is essential to safe operation and good
machine performance. Failure to maintain the
proper drip rate could result in machine component
damage.
1 While raising the platform, visually inspect the
oil lubricator sight gauge.
Result: There should be a maximum of 1 to 2
drops of oil visible in the sight gauge.
2 To adjust the drip rate, turn the oil flow control
valve clockwise to decrease the flow or
counterclockwise to increase the flow.
3 Repeat this procedure until the proper oil drip
rate is achieved.
1 oil lubricator flow control valve
2 oil lubricator sight gauge
46
A-19 C hec k the Air Filter/R egulator Canister - Air Models
A-19
Check the Air Filter/Regulator
Canister - Air Models
Genie specifications require that this procedure be
performed every 8 hours or daily, whichever comes
first.
It is essential to drain the air filter/regulator canister
of water to ensure good air motor performance and
service life. A water-filled canister could cause the
air motor to perform poorly and continued use may
cause component damage.
1
2
3
AWP Super Series • IWP Super Series
Check the air filter/regulator canister for any
water accumulation.
If water is visible, loosen the drain plug at the
bottom of the canister and allow the water to
drain out.
Tighten the drain plug.
1 air filter/regulator
2 air filter/regulator canister
3 air filter/regulator canister drain plug
September 2016
Part No. 38139