Replace The Auxiliary Platform Lowering Batteries - Genie AWP Super Series Service Manual

Hide thumbs Also See for AWP Super Series:
Table of Contents

Advertisement

September 2016
C-5 Repl ace the Auxiliary Platform Low ering Batteri es
C-5
Replace the Auxiliary Platform
Lowering Batteries
Genie specifications require that this procedure be
performed every 1000 hours or annually,
whichever comes first.
1
Turn the key switch off and remove the key.
2
Remove the ground control box cover
fasteners.
3
Open the ground control box and locate the
auxiliary battery pack inside.
4
Remove the fasteners that hold the battery
pack in place.
5
Carefully slide the battery pack out of the
holder.
Note: The wires connected to the battery pack are
very small. Be careful not to damage the wires.
6
Remove the old batteries from the pack.
7
Insert new batteries into the pack.
Note: Make sure the batteries are installed
correctly by following the diagram on the inside of
the battery pack.
8
Install the battery pack into the ground control
box and tighten the fasteners.
9
Close the ground control box cover and
tighten the fasteners. Do not overtighten.
Part No. 38139
AWP Super Series • IWP Super Series
Checklist C Procedures
Service Manual
61

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Iwp super series

Table of Contents