Tilt-Back Frame, Awp-36S And 40S Models; Tilt-Back Frame - Genie AWP Super Series Service Manual

September 2016
Tilt-back Fr am e, AW P-36S and 40S Mod els
6-1 6-1 Tilt- back Fr ame

Tilt-back Frame

How to Remove the Tilt-back
frame
1 Fully lower the platform.
2 Turn the key switch off and remove the key.
3 Maintain a firm grasp on the tilt-back frame
and remove the retaining pin. Lower the
tilt-back frame to the ground.
4 Remove the fasteners that mount the tilt-back
frame hinges to the base.
Note: Note the amount of shims used between the
hinges and the base.
5 Remove the frame from the machine.
How to Adjust the Loading Pivot
or Stop Bracket
Note: Check for side-to-side movement of the pivot
slider or stop bracket. They should have no
side-to-side clearance and not be too tight to cause
dragging or binding. Adjust if necessary.
1 Remove the tilt-back frame. Refer to Repair
Procedure, How to Remove the Tilt-back
Frame.
2 Remove the mounting fasteners from the
tilt-back frame hinges.
Part No. 38139

Tilt-back Frame, AWP-36S and 40S Models

AWP Super Series • IWP Super Series
3 Slide the pivot slider and the stop bracket out
of the frame and add shims as necessary to
obtain zero clearance and zero drag.
1 shock absorber assembly
2 tilt-back frame
3 shock absorber mounting bolt
4 loading pivot bar
5 loading stop bracket
Service Manual
101