Mast Assembly - Genie AWP Super Series Service Manual

Service Manual
Mast Components
10 Loosen the cylinder mounting bracket
fasteners
1 Bracket mounting fasteners
2 Cylinder mounting fasteners
3 Hydraulic cylinder
4 Cylinder mounting plate
11 Support the cylinder and carefully slide it out of
the bottom of the mast.
Crushing hazard. The lift cylinder
will fall unless it is properly
supported.
92
5-2 M ast As sem bly
5-2

Mast Assembly

How to Remove the Mast
Assembly - AWPS Models
1
2
3
4
5
6
7
AWP Super Series • IWP Super Series
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting
this procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is strongly recommended.
Fully lower the platform.
Turn the key switch off and remove the key.
Remove the platform. Refer to Repair
Procedure, How to Remove an Aluminum
Platform.
Remove the power pack. Refer to Repair
Procedure, How to Change a Power Pack.
AWP-36S and 40S models: Remove the
tilt-back frame. Refer to Repair Procedure,
How to Remove the Tilt-back Frame.
Attach an overhead crane to the lifting eye at
the top of the mast.
Place a saw horse in front of the machine
where the top of the mast will rest.
September 2016
Part No. 38139