How To Calibrate The Turntable Tilt Sensor - Genie S-45 XC Service And Repair Manual

Service and Repair Manual
Turntable Rotation Components
How to Calibrate the Turntable
Tilt Sensor
Note: Perform this procedure with the boom fully
retracted and in the stowed position and with the
machine on a firm, level surface.
Note: A digital level will be required to perform this
procedure.
1 Enter Service Mode. Refer to Repair
Procedure, How to Enter the Service Mode.
2 Press the settings button above the display
and navigate t the Sensor Calibrations menu.
3 Navigate to the Chassis Tilt Sensor calibration
screen.
4 Select and start the calibration procedure.
5 If the machine is not sufficiently level, the
procedure will fail with the message that the
chassis no not sufficiently level. Move the
machine to a more level location if this occurs.
6 The first calibration is machine pitch. This is
the pitch of the machine from the platform end
to the counterweight end of the machine.
7 Place the digital level onto the swing chassis
bearing plate, which is located to the left of the
fuel tank. Orient the level along the pitch axis
of the machine.
8 Enter the value as seen on the digital level into
the ground control display. If the digital level is
showing a negative value, enter it as a positive
number. Press OK when the value on the
ground control display matches the value of
the digital level (excluding the plus/minus
sign).
78 S-40 XC • S-45 XC • S-40 TraX • S-45 TraX
9 A graphic of the machine pitch will now be
shown on the display. By pressing the UP or
DOWN buttons, the graphic will change to
show the counterweight being uphill or
downhill. Select the image that corresponds to
the current pitch of the machine and press OK.
Turntable Pitch
1 uphill
2 downhill
10 The next calibration of the machine is the
machine roll. This is the angle of the machine
from side to side.
11 Place the digital level onto the swing chassis
bearing plate, which is located to the left of the
fuel tank. Orient the level along the roll axis of
the machine.
12 Enter the value as seen on the digital level
onto the ground control display. If the level is
showing a negative value, enter it as a positive
number. Press OK when the value on the
ground control display matches the value of
the digital level sensor (excluding the
plus/minus sign).
July 2019
Part No. 1286829GT