YOKOGAWA WT500 User Manual page 272

11.3 Configuring TCP/IP Settings
11-4
To Only Use DNS
6.
Use the cursor keys to select DHCP.
7.
Press SET to select OFF.
• Entering the IP Address
8.
Use the cursor keys to select IP Address.
9.
Press SET to display the IP address entry box.
10.
Use the cursor keys to enter the IP address of the WT500.
11.
Press SET or ESC to close the entry box.
12.
Enter all four octets of the IP Address.
• Entering the Subnet Mask
Enter the subnet mask according to the system or network that the WT500 belongs
to. If the system or network does not require a subnet mask, proceed to "Entering the
Default Gateway."
13.
Use the cursor keys to select Net Mask.
14.
Enter all four octets of the subnet mask of the network that the WT500 belongs to
just as you did for the IP address.
• Entering the Default Gateway
Enter the default gateway according to the system or network that the WT500 belongs
to. If the system or network does not require a default gateway, proceed to "Turning
On the DNS."
15.
Use the cursor keys to select Gate Way.
16.
Enter all four octets of the default gateway of the network that the WT500 belongs
to just as you did for the IP address.
• Turning DNS On
17.
Use the cursor keys to select DNS.
18.
Press SET to display the DNS selection box.
19.
Use the cursor keys to select ON.
20.
Press SET to confirm the selection.
The DNS settings appear.
IM 760201-01E