Manual Performance Tests - Keysight N5171B EXG Service Manual

Post-Repair Procedures and Operational Performance Verification
Post Repair Procedures

Manual Performance Tests

To ensure the signal generator is meeting all published specifications,
4-2
to be performed after a specific assembly has been repaired or replaced.
Table 4-2 Manual Operational Performance Verification Tests
Manual Operational Performance Verification Tests
The following performance verification tests are listed
in the order that they should be performed.
"I/Q Calibration (N5172B/82B only)" on
page 246
"Enhanced Factory Calibration" on page 247
"Running Self Test" on page 248
"Relative Frequency Range and Accuracy
Check" on page 250
"Leveled Output Power" on page 252
a
Phase Noise (N5181B/82B/83B only)
a. The Phase Noise test procedure is available as part of the N7822A EXG/MXG Series software.
242
lists the recommended manual operational performance verification tests
Replaced Assembly
X X
X X
X X X X X
X X
X X
Keysight X-Series Signal Generators Service Guide
Table
X X X X X
X
X
X