Assembly Replacement
Inner Top Cover
Inner Top Cover
Tools Required
— T-10 driver
Removal Procedure
Refer to
1. Disconnect the power cord.
2. Remove the outer-cover from the signal generator. Refer to
3. Place the signal generator flat with the front-panel facing you.
4. Using the T-10 driver, remove the eleven flat-top screws (1) from the inner
5. Using the T-10 driver, remove the screw (3) from the rear panel.
6. Remove the inner top cover.
Replacement Procedure
1. Reverse the order of the removal procedures.
2. Recommended torque for all screws is 9 in–lbs.
170
Figure 3-4
for this procedure.
on page
168.
top cover (2).
Keysight X-Series Signal Generators Service Guide
"Outer Cover"