Table of Contents
Advertisement
July 30th, 1996
System Switch 02
No
FUNCTION
Memory file transfer
0: Disabled
0
1: Enabled
1-2 Not used
Memory file printout
3
0: Disabled
1: Enabled
4
Not used
Software download area
0: All except the boot block
1: All areas, including the
boot block
5
Keep this bit at 0 except for
the rare cases when the
Flash ROM boot block has
to be rewritten.
Memory read/write by RDS
Bit 7
6
Setting
0
0
Always disabled
0
1
User selectable
6
1
0
User selectable
1
1
Always enabled
7
System Switch 03
No
FUNCTION
Length of time that RDS is
0
temporarily switched on
to
when bits 6 and 7 of
System Switch 02 are set to
7
"User selectable"
SERVICE TABLES AND PROCEDURES
COMMENTS
1: All messages in the memory are sent to the fax
number which is programmed as the service station.
Always reset this bit to zero after transfer.
Cross reference
Service station number programming: Function 13
Do not change the setting.
1: All SAF files can be printed using Function 54 or 55.
Always reset this bit after printing the messages.
Do not change the settings.
0: This is the normal setting. For normal software
downloads, do not change this bit switch.
1: Set this bit to 1 only when you need to rewrite the
boot block in the Flash ROM using Function 12.
Cross reference
Software Download: Section 4.1.20
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out, but
the user can temporarily switch RDS on to allow RDS
operations to take place. RDS will automatically be
locked out again after a certain time, which is stored in
System Switch 03 (see below). Note that if an RDS
operation takes place, RDS will not switch off until this
time limit has expired.
(1,1): At any time, an RDS system can access the
machine.
COMMENTS
00 - 99 hours (BCD).
This data is only valid if bits 6 and 7 of System Switch
02 are set to "User selectable".
The default setting is 24 hours.
4-19
BIT SWITCHES
Advertisement
Table of Contents
