Ricoh infotec 3671F Service Manual page 36

DETAILED SECTION DESCRIPTIONS
PRINTING
- User Setting: Fusing Lamp Off -
181°C
176°C
161°C
100°C
Room Temp
Warming up
After printing, the fusing lamp temperature drops to 161° C. Then, the fusing
lamp temperature will fall back to room temperature after 1 or 3 minutes,
depending on the system bit switch setting.
If the system bit switch is set to 5 minutes, the lamp temperature falls back to
100° C after 3 minutes, and then to room temperature after a further 2
minutes.
If the power saver mode timer is set to "no limit", the temperature stays at
161° C for 3 minutes, then goes down and stays at 100° C.
3 min
1 min
Printing Idle
2-19
5 min
Low temp
mode
June 30th, 1996
Energy Star Mode
H528D546.wmf