Ricoh infotec 3671F Service Manual page 40

DETAILED SECTION DESCRIPTIONS
PRINTING
Reduction Disabled
If bit 0 of printer switch 03 is at 0 (Disabled), the data will not be reduced.
However, if the incoming page is up to x mm longer than the copy paper, the
excess portion will not printed. The value of x can be from 0 to 15 mm. It is
determined by the setting of bits 4 to 7 of printer switch 03.
Hex value
0
0
F
Messages more than x mm longer than the copy paper will be printed out on
two pages in accordance with the setting of bit 1 of printer switch 00 as
explained earlier.
2.2.10. Paper Size Selection
If the machine has an optional paper feed unit installed, the paper size to use
is decided in accordance with the following rules.
•
If both trays contain the same paper size, the machine uses the paper
in the optional paper feed unit first.
•
If the received page has to be split up and printed on two pages, both
pages will be the same size.
•
If the trays contain different sizes, the paper size chosen for printing the
received fax message is selected in accordance with the following table
of priorities. The table assumes that reduction is enabled and that the
reduction ratio is 4/3.
Received Fax
Message Size
Letter
A4
F, F4
Legal
•
The paper size priority is graded from 1 to 4.
•
R: The data is reduced to fit on the printer paper.
Value of X
0
1
and so on until
15
Selected Paper Size
Letter A4
1 2
4(R) 1
4(R) 3(R)
4(R) 3(R)
2-23
June 30th, 1996
F, F4 Legal
3 4
2 3
1 2
2(R) 1