Ricoh infotec 3671F Service Manual page 190

July 30th, 1996
Code Meaning
6-04 G3 ECM - RTC not
detected
6-05 G3 ECM - facsimile data
frame not received within
18 s of CFR, but there
was no line fail
6-06 G3 ECM -
coding/decoding error
6-08 G3 ECM - PIP/PIN
received in reply to
PPS.NULL
6-09 G3 ECM - ERR received
6-10 G3 ECM - error frames
still received at the other
end after all
communication attempts
at 2400 bps
6-11 G3 ECM - printing
impossible because of a
missing first line in the
MMR coding
6-21 V.21 flag detected during
high speed modem
communication
6-39 V.21 signal not stopped
within 6 s
9-07 Paper non-feed or jam
at the paper entrance
9-08 Paper jam inside the
development area
9-09 Paper jam in the fusing
exit area
9-10 Toner end detected
9-12 Cover open detected
during printing
9-20 Laser diode failure
Suggested Cause/Action
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote terminal.
Replace the FCU or NCU.
Check the line connection.
Check connections from the NCU to the FCU.
Check for a bad line or defective remote terminal.
Replace the FCU or NCU.
Try adjusting the rx cable equalizer
Cross reference
Rx cable equalizer - G3 Switch 07 (PSTN)
Defective FCU.
The other terminal may be defective.
The other end pressed Stop during communication.
The other terminal may be defective.
Check for a noisy line.
Adjust the tx levels of the communicating machines.
See code 6-05.
Check for line noise.
Adjust the tx level (use NCU parameter 01 or the
dedicated tx parameter for that address).
Check the line connection.
Defective remote terminal.
Check for problems in the printer mechanism.
The other terminal may be defective or incompatible.
Replace the FCU.
If the problem persists, replace the FCU.
Cross reference
Paper non-feed - Section 7-2-2
Jam at the paper entrance - Section 7-2-2
If the problem persists, replace the FCU.
Cross reference
Paper jam - Section 7-2-2
If the problem persists, replace the FCU.
Cross reference
Paper jam - Section 7-2-2
Replace the DTM.
Close the cover, or check the cover sensors.
If the problem persists, replace the MCB.
Cross reference
LD failure - Section 7-3
7-27
TROUBLESHOOTING
ERROR CODES