Ricoh infotec 3671F Service Manual page 188

July 30th, 1996
Code Meaning
0-30 The other terminal did
not reply to NSS(A) in AI
short protocol mode
0-52 Polarity changed during
communication
1-00 Document jam
1-01 Document length
exceeded the maximum
1-10 Paper at the scan line
when the power was
turned on.
1-17 Document jam in the
feed-out area
1-20 Paper did not reach the
fusing exit at the end of
printing
1-21 Paper present at the
fusing exit after printing
1-30 Paper ran out during
printing
1-34 Paper ran out after
printing
1-71 The cover was opened
during printing
2-10 The modem cannot enter
tx mode
2-11 Only one V.21
connection flag was
received
2-12 Modem clock irregularity
Suggested Cause/Action
Check the line connection.
Check the FCU - NCU connectors.
Try adjusting the tx level and/or cable equalizer
settings.
The other terminal may not be compatible.
Cross reference
Dedicated tx parameters - Section 4-4
Check the line connection.
Retry communication.
Incorrectly inserted document or unsuitable
document type.
Check the ADF drive components and sensors.
Cross reference
ADF mechanical problems - Section 7-2-1
Try changing the maximum acceptable document
length.
Divide the document into smaller pieces.
Check the ADF drive components and sensors.
Cross reference
Max. document length - Scanner switch 00, bits 2
and 3
ADF mechanical problems - Section 7-2-1
Remove the paper.
Check the scan line sensor.
Cross reference
ADF mechanical problems - Section 7-2-1
Clear any debris from the sensor actuator.
Check the ADF drive components and sensors.
Cross reference
ADF mechanical problems - Section 7-2-1
Remove the paper.
Check the printer drive components and sensors.
Cross reference
Printer mechanical problems - Section 7-2-2
Remove the paper.
Check the printer drive components and sensors.
Cross reference
Printer mechanical problems - Section 7-2-2
Add paper in the paper tray.
Add paper in the paper tray.
Close the cover.
Replace the FCU.
Change the FCU.
Replace the FCU.
7-25
TROUBLESHOOTING
ERROR CODES