Steering Post/Tie Rods - Arctic Cat DVX 250 2007 Service Manual

Steering Post/
Tie Rods
NOTE: Critical torque specifications are located
in Section 10.
REMOVING
1. On the Utility model, remove the front rack and
front center panel (see Body in this section). On
the DVX model, proceed to step 2.
2. Remove the steering post cover (DVX model) or
the instrument pod (Utility model) (see Steering
Post Cover/Instrument Pod in this section); then
remove the cap screws securing the handlebar to
the steering post. Account for two handlebar
holders.
3. Lift the handlebar out of the lower handlebar
holders and lay the handlebar forward.
4. Remove the cotter pins and slotted nuts securing
the tie rod ends to the steering post arm; then
disconnect the tie rods from the arm.
8-2
KM598C
KM189A
Back to TOC
5. Remove the cotter pin and slotted nut from the
lower end of the steering post; then remove the
upper steering shaft support block. Account for
a cable guide, two steering support blocks, and
the upper steering post bushing.
.
6. Remove the steering post from the ATV.
Back to Section TOC
KM590
KM588
KM589
Next