Arctic Cat DVX 250 2007 Service Manual page 36

Utility Model
1. Remove the seat; then remove the battery box
cover.
2. Remove the negative cable from the battery;
then remove the positive cable.
3. Drain the coolant, engine oil, and transmission
gear lubricant; then install the drain plugs and
tighten to specifications.
Back
KM330
KM331
KM133A
Back to TOC
4. Remove the gas tank cover panel and gas tank
vent hose.
5. Remove the side panels; then remove the front
rack and front fenders (see Section 8).
6. Remove the air filter housing (see Section 4).
7. Remove the gas tank (see Section 4).
8. Remove the muffler assembly (see Section 8).
9. Remove the carburetor (see Section 4).
10. Remove the coil (see Section 5).
11. Disconnect the stator connector, shift position
connector, trigger coil connector, and coolant
temperature sensor.
Back to Section TOC
KM314A
3
KM314B
KM106A
Next
3-7