Arctic Cat DVX 250 2007 Service Manual page 127

2. Disconnect the negative battery cable first; then
the positive cable.
3. Remove the battery hold-down strap; then
remove the battery.
4. Remove the front and rear racks; then remove
the cap screws securing the front center panel
and remove the panel.
5. Remove the cap screws and flange nuts securing
the mud guards to the front and rear fenders;
then remove the cap screws securing the mud
guards to the front rests and remove the mud
guards.
6. Remove the side panels; then remove the cap
screws and flange nuts securing the front and
rear fenders to the frame and fender supports.
Back
8-6
KM793A
KM308A
KM789A
Back to TOC
7. Disconnect the left and right headlight connec-
tors; then disconnect the taillight.
8. Remove the gas tank cover; then remove the
shift knob and front and rear fenders.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all body components with soap and water.
2. Inspect the body and fenders for cracks.
3. Inspect threaded areas of all mounting studs for
stripping.
4. Inspect for missing decals.
INSTALLING (DVX Model)
1. Fit the body over the handlebar and rotate into
normal mounting position.
2. Using the existing hardware, secure the front
fenders to the fender supports; then connect the
headlight.
3. Using the existing hardware, secure the rear
fenders to the forward fender supports; then
secure the rear fender to the frame with four cap
screws and flange nuts. Tighten securely.
Back to Section TOC
KM799B
KM797
Next