Arctic Cat DVX 250 2007 Service Manual page 121

NOTE: Make sure each wheel is installed on its
proper hub as noted in removing (the "rotation
arrow" must indicate forward direction of rotation).
2. Tighten to specifications (see Section 10).
CHECKING/INFLATING
1. Using an air pressure gauge, measure the air
pressure in each tire. Adjust the air pressure as
necessary to meet the recommended inflation
pressure.
Back
SP054
AF612D
Back to TOC
2. Inspect the tires for damage, wear, or punctures.
! WARNING
Do not operate the ATV if tire damage exists.
NOTE: If repair is needed, follow the instructions
found on the tire repair kit or remove the wheel
and have it repaired professionally.
NOTE: Make sure all tires are the specified size
and have identical tread pattern.
3. Check the front wheel toe-in and toe-out and
adjust as necessary (see Section 8).
4. Test drive the ATV on a dry, level surface and
note any pulling to the left or right during accel-
eration, deceleration, and braking.
NOTE: If pulling is noted, measure the circumfer-
ence of the front and rear tires on the pulling side.
Compare the measurements with the tires on the
opposite side. If pulling is noted during braking
only, check and adjust the brakes as necessary
and recheck operation (see Section 2).
5. Increase the air pressure in the tires with the
smallest circumference measurement until all
tires are equal in circumference.
6. Repeat steps 4-5 as necessary to ensure proper
handling.
Back to Section TOC
7
7-11