Transmission Lubricant; Drive Chain (Dvx Model) - Arctic Cat DVX 250 2007 Service Manual

Table of Contents

Advertisement

2. If low, add SAE approved 80W-90 hypoid gear
lube as necessary.
To change the lubricant, use the following proce-
dure.
1. Place the ATV on level ground.
2. Loosen the fill plug.
3. Remove the cap screws securing the rear drive
gear guard; then remove the guard.
4. Drain the lubricant into a drain pan by removing
the drain plug from the bottom of the rear drive.
NOTE: If the rear drive lubricant is contaminated
with water, inspect the drain plug, fill plug, and/or
bladder.
5. After all the lubricant has been drained, install
the drain plug and tighten securely. Install the
rear drive gear guard and tighten the cap screws
securely.
6. Pour the appropriate amount of recommended
lubricant into the fill hole. Remove the level
plug and check for appropriate level.
7. Install the fill plug.
! CAUTION
Water entering the outer end of the axle will not be
able to enter the rear drive unless the seals are dam-
aged.

Transmission Lubricant

Change the lubricant according to the Periodic
Maintenance Chart. When changing the lubricant,
use approved SAE 80W-90 hypoid gear lube.
To change the lubricant, use the following proce-
dure.
Back
KM131A
Back to TOC
1. Place the ATV on level ground.
2. Loosen the fill plug; then remove the transmis-
sion drain plug and drain the transmission lubri-
cant.
3. Install the drain plug and tighten securely.
4. Remove the fill plug and pour the appropriate
amount of recommended lubricant into the fill
hole.
5. Install the fill plug and tighten securely.
6. Check the area around the drain plug for leak-
age.
Drive Chain
(DVX Model)
Drive chain condition and adjustment should be
inspected each day before the ATV is operated.
Always follow the following guidelines for inspect-
ing and servicing the drive chain.
! WARNING
Failure to inspect and maintain the drive chain can
be hazardous. Operating the ATV with the drive
chain in poor condition or improperly adjusted can
cause an accident resulting in possible injury.
Back to Section TOC
2
KM104A
KM106A
Next
2-9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Utility 250 2007

Table of Contents