To Define Test Output - Agilent Technologies B1500A Training Manual

Module 10
Creating Your Test Definitions

To Define Test Output

2. Define the analysis parameters
1
6. Select the multi display mode
Comply with above level
Enable
Disable
3. Specify X axis and Y axis
5. Select parameters
4. Select variables to list
to display
The test output setup is optional. If you have the following requirements, define the analysis
parameters and set the display parameters.
-To send the test result data to the subsequent tests in an application test
-To make the program branching depends on the test result
-To make the calculation using the test data in the Test Contents
-To display/record the test result of this application test
-To change the multi display mode of this application test
To define the test output:
1. Check the Define own Output Parameters box.
2. Click the Define Analysis Parameters... button. And define the analysis parameters on the
Analysis Parameter Definition window.
3. Specify X axis and Y axis of the X-Y Graph of the Data Display window.
4. Select variables to list in the List Display area of the Data Display window.
5. Select variables to display in the Parameters area of the Data Display window.
6. Select the multi display mode using the Allocate Data Display for each test pull-down menu.
Note: If the multi display mode is Disabled, the all test result data will be displayed on the singular
Data Display window. If the multi display mode is Enabled, the test result data of the same test setup
name will be displayed on the exclusive Data Display window and the test result data of the different
test setup name will be displayed on the new Data Display window.
10-20