Agilent Technologies B1500A Training Manual page 55

Start_xxxx.exe
• Arguments:
Example:
–a GPIB0::5::INSTR –l C:\temp\prb.log
• Response:
<Response>
<Break>status</Break>
<Target>device_id</Target>
</Response>
status:
device_id:
Example:
<Response>
<Break>0</Break>
<Target>waf1a:3 1</Target>
</Response>
To specify the start procedure in the Repeat Measurement Setup dialog box, enter the full path name
of Start_xxxx.exe into the Start Procedure field.
After the repeat measurement is started, this procedure displays the Device ID Entry dialog box and
waits for your input. On the dialog box, enter a string used for the prefix of device_id. After that,
you will see the Start Confirmation dialog box that is used to confirm your wafer setup status. Load
wafer and perform wafer alignment, then click OK on the dialog box. The procedure moves wafer
chuck to the first probing position, checks the prober status, gets the X-Y coordinate of the probing
position, and sets the wafer chuck to the UP position. At last, the procedure returns the response.
The status is 0 or 1. It is used for the EasyEXPERT repeat measurement stop function. When the
Procedure return condition box is checked in the Repeat Measurement Setup dialog box, the repeat
measurement will be stopped if status is not 0.
The device_id is a string for the Device ID of the test result record. When the Automatically fill in
Device ID box is checked in the Repeat Measurement Setup dialog box, the device_id will be entered
to the Device ID of the test result record.
If you use the subsite procedure, the flowchart must be changed. See page 11-18.
Note: To ignore the Arguments, set the GPIB address and log file name in the prober_info.ini.
-a GPIB_address
-l log_file_name
XML format data
0 (no error) or 1
prefix:coordinate
11-13
Advanced Definitions and Operations
Start
Displays Device ID Entry dialog box
Updates prober_info.ini file
Displays Start Confirmation dialog box
Moves to the first position
Prober error?
No
Gets X-Y coordinate
B
Prober error?
No
Chuck up
Returns response
End
Module 11
Yes
Yes