How To Install The Rack-Mount Kit (Option 1Cm); How To Install The Rack-Mount And Handle Kit (Option 1Cp) - Keysight E5061B Installation Manual

WA R N I N G

How to Install the Rack-mount Kit (Option 1CM)

How to Install the Rack-mount and Handle Kit (Option 1CP)

C A U T I O N
Network Analyzer
If the installed front handle becomes damaged, replace it with a
new one immediately. A damaged handle can break while moving
or lifting the instrument and cause personal injury or damage to
the instrument.
The rack-mount kit includes two flanges (locking side plates)
for mounting the E5061B on a rack (482.6 mm/19 inches)
conforming to the EIA Standard. While referring to
install the rack-mount kit by following these steps.
Step 1.
Remove the adhesive-backed trim strip (1) from
each side of the outer frame of the E5061B front panel.
Step 2.
Use the screws provided to mount a rack-mounting
flange (4) on each side of the E5061B front panel frame.
Step 3.
Remove the four bottom feet of the E5061B (lift the
bar marked TAB on the inner side of the foot and slide the
foot toward the bar).
Step 4.
Mount the E5061B on the rack.
The rack-mount and handle kit includes both the
rack-mounting flanges (locking side plates) and front
handles. While referring to
by following these steps.
Step 1.
Remove the adhesive-backed trim strip (1) from
each side of the outer frame of the E5061B front panel.
Step 2.
Use the screws provided to mount a front handle
(2) and rack-mounting flange (4) on each side of the E5061B
front panel frame.
Use both a front handle and a rack-mounting flange in the same time
certainly. Do not attempt to install flanges or handles separately
with hardware provided. Serious electrical damage will occur to the
instrument.
Figure 3, install the rack-mount kit
1
Installation
Figure 3,
25