Starting The E5061B; Turning The Power On And Off - Keysight E5061B Installation Manual

1
Installation

Starting the E5061B

Turning the Power ON and OFF

30
This section describes how to turn on/off the E5061B power
and how to cut off the power supply in an emergency.
The standby switch can turn/off the E5061B. The color on
the button shows the status, as shown below:
Indicator Color
Green
Orange
Red
Perform the following steps to turn the power ON or OFF.
Turning the Power ON
Step 1.
Confirm if the Line Switch on the rear panel is on.
The switch should always be turned on.
Step 2.
Press the standby switch once and it changes to
green color.
This operation turns ON the power, and the E5061B starts
the self-test.
Step 3.
Confirm that the self-test indicates normal
operation.
Normal operation is confirmed by the self-test if no error
message appears.
Turning the Power OFF
Step 1.
To turn off the power of the E5061B, first, press
this standby switch or send a shutdown command from the
external controller to activate the shutdown process (the
process of software and hardware necessary to turn off the
power supply). This puts the E5061B into the standby state
and the button changes to orange color.
Description
Normal power on status
Standby status
Illegal power on status
Network Analyzer