Sp6-Xxx (Peripherals) - Ricoh J-P2 Service Manual

PRINTER ENGINE SERVICE MODE

SP6-XXX (Peripherals)

6
(Class 1, 2, and 3)
006 [DF Registration Adj.] DF Registration Adjustment
1 Side-to-Side
2 Leading Edge
3 Buckle: Duplex Front
4 Buckle: Duplex Rear
5 Rear Edge Erase
007 [ADF Input Check]
1 Group 1
2 Group 2
[ADF Output Check]
008
1 Fee-in Motor Fwd.
2 Feed-in Motor Rev.
3 Drive Motor Fwd.
4 Reverse Motor Fwd.
5 Reverse Motor Rev.
6 Feed Clutch
7 Inverter Solenoid
8 Pick-up Motor Fwd.
9 Pick-up Motor Rev.
[DF Free Run]
009
1 Duplex Mode
2 Stamp Mode
010 [Stamp Position Adj.] Fax Stamp Position Adjustment
1 Stamp Position Adj.
016 [Original Size Priority] Original Size Detection Priority
1 Original Size Priority
Mode No.
NV
CF
CF
CF
CF
NV
CF
NV
CF
Function / [ Setting ]
* Adjusts the side-to-side and leading registration of
originals with the ARDF.
[ -30 to 30 / 0 / 0.1 mm/step ]
Adjusts the amount of paper buckle to correct
original skew for the front and rear sides.
[ -4.2 to 4.2 / 0 / 0.1 mm/step ]
Adjusts the erase margin at the original trailing
edge.
[ -20 to 10 / 0 / 0.5 mm/step ]
Displays the signals received from the sensors
and switches of the ARDF. (See 5.4.2)
Activates the electrical components for functional
check.
It is not possible to activate more than one
component at the same time.
Performs a DF free run in duplex mode or stamp
mode.
* Adjusts the horizontal position of the stamp on the
scanned originals.
[ -3.5 to 3.5 / 0 / 0.5 mm/step ]
* Specifies the original size for a size detected by
the original sensor, since original sensors cannot
recognize all sizes.
[ 0 or 1 / 0 / - ]
0: Setting 1
1: Setting 2
Setting 1
Bit 7 A4 (L)
Bit 6 11" x 15"
Bit 5 DLT (L)
Bit 4 LT (S)
Bit 3 LT (L)
Bit 2 LG (L)
Bit 1 A4 (L)
Bit 0 8K (L)
Bits used for detection differ depending on
destination as shown below.
Bit 7 to 6: Only for Japan
Bit 5 to 2: Only for US
Bit 1 to 0: Only for EU/AA
5-60
17 January, 2003
Setting 2
LT (L)
DLT (L)
11" x 15"
US Exec (S)
8" x 10" (L)
F4 (L)
16K (L)
DLT (L)